EnglishSvenska

264x176p 2.7 Inch E-Ink Display HAT for Raspberry Pi and Jetson Nano

by Waveshare
431 kr 345 kr

This is a 3-Color small-sized E-Ink Display HAT for Raspberry Pi and Jetson Nano. The 2.7-inch E-Ink HAT has a display quality of 264x176 pixels. The colors on this E-Ink include White, Red, and Black and the HAT supports the SPI interface. This is an ultra-low-consumption E-Ink Display because the power is only required when it has to refresh the image. There is no backlight so it keeps the image on display for a long time without using power. The view angle >170o is reasonable especially when you use this display for industrial instruments and shelf labels. This display HAT also supports controller boards including Arduino and Nucleo.

Features of 3-Color 264x176p 2.7-inch E-Ink Display HAT for Raspberry Pi and Jetson Nano

  • There is no backlight so it is a power-efficient display HAT
  • Doesn’t need the power to hold the image on display because it uses power only when it refreshes the image
  • 40-Pin GPIO (Raspberry Pi Compatible)
  • Compatible with Jetson Nano and Raspberry Pi Boards
  • Controller boards supported via SPI interface (Nucleo, Arduino, and Raspberry Pi)
  • 3V~5V MCUs compatible onboard Voltage Translator
  • Manual and development resources for STM32, Arduino, Jetson Nano, and Raspberry Pi are available

Specs of 3-Color 264x176p 2.7-inch E-Ink Display HAT for Raspberry Pi and Jetson Nano

  • Operation Voltage: 3.3V~5V Compatible
  • Display Colors: Red, White, Black
  • Screen Size: 2.7-Inch
  • Display Quality/Resolution: 264x176 pixels
  • Supports SPI Interface (3-Wire and 4-Wire Compatible)
  • Dot-Pitch 0.255x0.255
  • GrayLevel – 2
  • View Angle >170o
  • 4mW (typ.) Refresh Power
  • Standby Power <0.017mW
  • Full-Refresh-Time: 15 Seconds
  • Dimensions of the Display: 57.29mm x 38.19mm
  • Outline (Edge-to-Edge) Dimensions: 85mm x 56mm

Items Included

  • 1x 2.7-inch E-Ink Display HAT for Raspberry Pi and Jetson Nano
  • 1x 8-Pin 20cm PH2.0
  • 2x Screw pack (Raspberry Pi compatible / 2 screws in each pack)